The Supported Versions of Ignite-UX document has been updated and can be found on the Support Information page.
The FAQs page has been updated.
The following web-only documents, found on the Information Library page, have been updated:
Ignite-UX Quick Start Guide
Ignite-UX Installation Booting white paper
Supports new hardware enabled by the HP-UX release.
Improved agile I/O support in config files to allow disk specification by Hardware Path, World-Wide ID, SAS Physical Location, and Device ID.
SAS recovery issues addressed by agile I/O improvements to support SAS Physical Location in config files.
Significantly less time required for kernel build during install for some systems with small memory configurations.
Supports new hardware enabled by the HP-UX release.
This release also includes defect fixes.
Install kernel no longer updates SAS adapter firmware, which resolves SAS adapter firmware upgrade issues.
Support for USB 2.0 I/O protocol during install.
Enhanced I/O filter and search capabilities for large numbers of disks.
Supports new hardware enabled by the HP-UX release.
This release also includes defect fixes.
An issue with an unqualified configuration change when running certain commands was resolved. See HP Security Bulletin HPSBUX02249.
This release also includes defect fixes.
Pre-enable support for Veritas VxVM and VxFS 5.0 products by Symantec.
HP-UX 11.00 reached the end of its support life at the end of December, 2006. Support for HP-UX 11.00 was removed from this release of Ignite-UX.
Supports new hardware enabled by the HP-UX release.
This release also includes defect fixes.