Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
 A6826A Fibre Channel Mass Storage Adapter Installation Guide: HP-UX & OpenVMS Networking > Chapter 2 OpenVMS Installation

Install Adapter
» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Index

spacerspacerspacer
spacer
spacer
  		 
 

Installing the A6826A Adapter (all systems except Superdome)

CAUTION: The following procedure should only be performed by an HP Authorized Service Provider. Failure to properly complete the steps in this procedure may result in erratic system behavior or system failure and may void the warranty. For assistance with this procedure, contact your local HP Authorized Service Provider.

Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety precautions could result in damage to equipment.

NOTE: See the system documentation for information about how to safely shut down your system and obtain access to expansion slots.

  1. Shut down the system.

  2. Install the adapter in an available PCI slot.

  3. Attach fiber cabling to the adapter. The A6826A adapter uses a fiber optic cable terminated with an LC connector.

For installation instructions see the system documentation.

CAUTION: The optical port protector is used only to protect the adapter port when it is not in use. Do not use the protector as a diagnostic tool.

Figure 2-1  A6826A Dual Port Fibre Channel Adapter

A6826A Dual Port Fibre Channel Adapter


Driver Software
  		 


Attach Other Devices  
Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2004-2007 Hewlett-Packard Development Company, L.P.