 |
» |
|
|
|
This section describes how to use the TUI and
the CLI to verify whether the SFM software is removed successfully. Verifying Removal Using the TUI | |
To verify whether the SFM software is removed
successfully, complete the following steps: Log
in to the system as a superuser. Click Logfile in the Remove Window. If there are no errors in the Logfile, the SFM software is removed successfully. If the SFM software is
not removed properly, you must repeat the removal procedure. See “Removing the SFM Software” for instructions
on how to remove the SFM software. For
information about errors related to the removal of SFM, enter the
following command at the HP-UX prompt: # swjob -a log <jobid> @ <system name>:/ The jobid is available in the Logfile.
Verifying Removal Using the CLI | |
To verify if the SFM software is removed successfully,
complete the following steps: Log
in to the system as a superuser. Enter
the following command at the HP-UX prompt: # swjob If the output contains no errors, the SFM software
is removed successfully. If the SFM software is not removed properly,
you must repeat the removal procedure. See “Removing the SFM Software” for instructions on how to remove
the SFM software. For
information about errors related to the removal of the SFM software,
enter the following command at the HP-UX prompt: # swjob -a log <jobid> @ <system
name>:/ The jobid is available in the output of the swjob command.
|
Printable version
