 |
» |
|
|
|
This section describes how to use the TUI and the CLI
to verify whether the SFM software is removed successfully. Verifying Removal Using the TUI | |
To verify whether the SFM software is removed successfully,
complete the following steps: Log in to the
system as a superuser. Click Logfile in the Remove Window. If
there are no errors in the Logfile, the SFM software
is removed successfully. If the SFM software is not removed properly, you
must repeat the removal procedure. See “Removing the SFM Software” for
instructions on how to remove the SFM software. For information
about errors related to the removal of SFM, enter the following command at
the HP-UX prompt: # swjob -a
log <jobid> @ <system name>:/ The jobid is available in the Logfile.
Verifying Removal Using the CLI | |
To verify if the SFM software is removed successfully,
complete the following steps: Log in to the
system as a superuser. Enter the following
command at the HP-UX prompt: # swjob If the output contains no errors, the SFM software is
removed successfully. If the SFM software is not removed properly, you must
repeat the removal procedure. See “Removing the SFM Software” for
instructions on how to remove the SFM software. For information
about errors related to the removal of the SFM software, enter the following
command at the HP-UX prompt: # swjob
-a log <jobid> @ <system name>:/ The jobid is available in the output of the swjob command.
|
Printable version
