 |
» |
|
|
|
This section describes how to verify the SFM software
installation using the TUI and the CLI. Verifying the Installation Using the TUI | |
To verify the SFM software installation, complete the
following steps: Log in to the
system as a superuser. Click Logfile in the Install window, as shown in the following figure: The Logfile, which includes details
about the installation, is displayed. If there are no errors in the Logfile,
the SFM software is installed properly. If the SFM software is not installed
properly, you must repeat the installation procedure. For information
about errors related to installation, enter the following command at the HP-UX
prompt: # swjob -a log <jobid> @ <system name>:/ The jobid is available in the Logfile, as underlined in the Logfile window,
in the following figure: For example, enter the following command at the HP-UX
prompt: # swjob -a log iemlhamia-0013 @ iemlhamia.india.hp.com:/
Verifying the Installation Using the CLI | |
To verify your installation using the CLI, complete the
following steps: Log in to the
system as a superuser. Enter the following
command at the HP-UX prompt: # swjob If the output contains no errors, the SFM software is
installed properly. Otherwise, you must install the SFM software again. A sample output is shown in the following figure: For information
about installation-related errors, enter the following command at the HP-UX
prompt: # swjob -a log <jobid>
@ <system name>:/ For example, enter the following command at the HP-UX
prompt: # swjob -a log iemlhamia-0005 @ iemlhamia.india.hp.com:/
|
Printable version
