This section describes how to install the HP-UX PAM RADIUS A.01.00 software. It also discusses the system and patch requirements for installing the HP-UX PAM RADIUS A.01.00 software.
System Requirements |
 |
Table 1 lists the system requirements for installing the HP-UX PAM RADIUS A.01.00 software.
Table 1 System Requirements for Installing the HP-UX PAM RADIUS A.01.00 Software
| Component | Requirement |
|---|
| Operating System | |
| Hardware | |
| Disk space | Approximately 32 MB of disk space |
Patch Requirements |
|
You need not install any patches before installing the HP-UX PAM RADIUS A.01.00 software.
Installation Procedure |
|
To install the HP-UX PAM RADIUS A.01.00 software, complete the following steps:
Log in as superuser.
Download the HP-UX PAM RADIUS depot file from the following web address:
http://software.hp.com .
Move the depot to the /tmp directory.
Verify that the depot is downloaded correctly by entering the swlist command.
|
| |
|
 | NOTE: The swlist and swinstall commands require that the full path name to the source depot be specified. For example: swlist -d @ /tmp/<depot_name>
# Initializing...
# Contacting target "localhost"...
#
# Target: localhost:/tmp/PAMRADIUS.depot
#
#
# Bundle(s):
#
HP-UX-PAM-RADIUS A.01.00.00 HP-UX PAM RADIUS |
|
|
| |
|
To install the HP-UX PAM RADIUS software, enter the swinstall command, as follows:
swinstall -s /tmp/<depot_name> \*
|
To configure the HP-UX PAM RADIUS A.01.00 software, edit the /etc/pam.conf and /etc/raddb/server files.
For more information on configuring the HP-UX PAM RADIUS A.01.00 software, see /etc/raddb/quickstart.txt.
Printable version
