The stopsys command implements the actions to be taken to shut down the system.
The following procedure describes the steps necessary to shut down the HP XC system:
Log in to any node as superuser.
Logging in to the head node is the preferred node for shutting down the system.
If your system has been configured for improved availability, and you are shutting down the HP XC system with the intention of reimaging it, enter the transfer_from_avail command:
If you are shutting down the system without reimaging it, ignore this step.
Chapter 10 describes imaging.
Enter the stopsys command to shut down the HP XC system. If necessary, you can specify a delay (in minutes) with the --delay option:
The stopsys command initiates a shutdown command on the nodes and starts a countdown. The stopsys command forces the node to power off if it does not power off after the countdown. You can use the --hard option to ignore the countdown and power the nodes off immediately.
For additional information about the stopsys command, see stopsys(8).
Printable version
