Storage Management Initiative Specification (SMI-S) is a Storage Networking Industry Association (SNIA) standard that enables interoperable management for storage networks and storage devices. HP SIM uses this standard to discover and manage the storage systems it supports.
You must have a storage system’s WBEM SMI-S provider installed and configured on a managed node for HP SIM to discover SAN storage. This includes storage devices such as Fibre Channel disk arrays, switches, tape libraries, or hosts (with Fibre Channel host bus adapters.)
See the HP SIM SMI-S Provider webpage, http://www.hp.com/go/hpsim/providers, to view the latest information regarding HP SIM support for a particular device. This webpage offers information on obtaining, installing, and configuring SMI-S providers.
Installing SMI-S providers |
 |
Each storage vendor provides the SMI-S provider and installation instructions for its storage system. The webpage referenced in the previous section provides information on obtaining SMI-S providers. Also, consult the storage vendor’s website or representative for more information regarding their SMI-S providers. For each storage system:
Verify that the applicable SMI-S provider is installed.
If the SMI-S provider is not installed, obtain and install it per the vendor’s installation instructions.
Verifying SSL |
|
HP SIM requires that Secure Sockets Layer (SSL) is enabled for the SMI-S provider in order to discover and manage the storage system that the provider supports. Verify that SSL is enabled for each SMI-S provider.
Configuring SMI-S providers |
|
Occasionally, it might be necessary to modify an SMI-S provider’s port number or password. Use the provider’s documentation to perform these modifications.
For example, if two CIMOMs exist on the same host, you must configure them to use different ports to communicate with the CMS.
Configuring HP SIM to discover storage systems |
|
After verifying that each storage system’s SMI-S provider is installed and configured, configure HP SIM to discover the storage systems by performing the following steps:
Enter the user name and password for each provider’s SMI CIMOM in the Default WBEM settings section on the Setting Global Protocols page.
Add each SMI CIMOM IP address to the System Automatic Discovery task or to the Creating a New Discovery task. See the HP SIM User Guide at http://docs.hp.com/en/index.html for more information.
HP SIM discovers the storage systems after the next automatic discovery task. If you want to discover your storage systems immediately, run the discovery task as described in the “Running a Discovery Task” section of the HP SIM User Guide at http://docs.hp.com/en/index.html.
Printable version
