5.3 Listing the System Configuration

This section describes how to determine your system configuration group.

The factory System Load Tape (SLT) does not contain a default I/O configuration. During an installation, you must specify the appropriate factory configuration group when booting the system immediately after installing the factory SLT. Listing the system configuration uses the off-line diagnostic tool, Mapper. To get help using MAPPER, type help at the MAPPER prompt, and see Figure 5-1 “Sample Listing MAPPER Output” for a sample listing.

To list the system configuration:

Check that all hardware peripherals are attached and powered on.
Start ODE.
ISL>ODE
Display hardware configuration.
ODE>RUN MAPPER
The figure on the following page is a sample of a MAPPER display.
Record the I/O configuration for your system.
Find the MPE/XL Model String. Then refer to Appendix B “Configuration Tables” for the configuration group name for your HP 3000 model in the SCSI, HP-IB, or HP-FL (Alink) column. For example, for a Model 995, the SCSI group is CONFG995. It is very important to have the exact group name. Check carefully for numbers zero and 1 and letters O and I.

Exit mapper.

ODE>EXIT

Figure 5-1 Sample Listing MAPPER Output

STARTING EXECUTION OF MAPPER
Processor Identification:
  Hardware Model: 280H, Revision: 0
  Software Model: 4H, Revision: 0
  Hardware ID: 0, Software ID: 142828241 (unsigned decimal)
  Software Cap: 0x100000061
  MPE/XL Model String: 957SX
  Processor Board Revisions:
    CPU - CPU Chip:                   3
    System Controller:                3
    PDC - Processor Dependent Code   1.5
  Cache and TLB sizes:
    Instruction Cache: 64 K bytes, Instruction TLB: 96 entries
    Data Cache:        64 K bytes, Data TLB:        96 entries
  Co-processors: None installed
I/O Configuration:
                                   Type HW     SW      Revisions
Path   Component Name              ID   Mod    Mod     Hdwr   Firm
8      CIO Adapter                 8H   5H     10H     0      0
8.0    HP-IB card                  2H   -      -       6      2912
16     CIO Adapter                 8H   5H     10H     0      0
16.0   HP-IB card                  2H   -      -       6      2912
52     HP-IB SCSI                  4H   14H    39H     0      0
         Resetting SCSI Bus ...
52.0.0  HPC1503 (X) /HPC1520B DDS tape  -  -    -       -     1009
52.2.0  HPA1999A CD-ROM drive           -  -    -       -     0272
52.5.0  HPC3010M1 disc drive            -  -    -       -     0B04
52.6.0  HPC2247M1 disc drive            -  -    -       -     0B04
56     HP-PB LAN/Console                2H 14H  60H     0     0
62     Processor                        0H 280H 4H      0     0
63     Memory (128 M bytes)             1H 14H  9H      0     0
Slot 1A - 32M
Slot 1B - 32M
Slot 5A - 32M
Slot 5B - 32M
Resetting the Boot Device . . .
Done.
RUN COMPLETED.
ODE>exit
ISL>

Listing the System Configuration completed. Go to the next section on your checklist.

5.3 Listing the System Configuration

Technical documentation

» Table of Contents

» Glossary

» Index